New Precision Spray-Coating Enables Complex Perovskite Solar Cell Designs

Researchers have developed a new precision spray-coating method that enables complex perovskite solar cell designs and could be used to scale up for mass production.

Perovskites, a highly promising alternative to the silicon which is used to make most of today’s solar cells, needs new manufacturing processes to make them practical for commercial production. And researchers at Mahidol University in Thailand have done just that. Developing a new precision spray-coating method that enables more complex perovskite solar cell designs and could be used to scale up for mass production.

Perovskites are promising for next-generation solar cells because they absorb light and convert it to energy with better efficiency and potentially lower production costs than silicon. Perovskites can even be sprayed onto glass to create energy-producing windows.

“Our work demonstrates a process to deposit perovskite layer by layer with controllable thicknesses and rates of deposition for each layer,” said research team leader Pongsakorn Kanjanaboos from the School of Materials Science and Innovation, Faculty of Science, Mahidol University in Thailand. “This new method enables stacked designs for solar cells with better performance and stability.”

Their work which was published in the Optical Society (OSA) journal Optical Materials Express, the team describe their new spray coating method, called sequential spray deposition, and show that it can be used to create a multilayer perovskite design. Applying different perovskite materials in each layer can allow customisation of a device’s function or the ability to meet specific performance and stability requirements.

koth amratisha and pongsakorn kanjanaboos
The researchers demonstrated the technique by depositing a perovskite material with higher stability on different perovskite material with better electrical properties. Applying different perovskite materials in each layer can be used to customize a device’s function or meet specific performance and stability requirements. Pictured are the paper’s first author undergraduate student Koth Amratisha (left) and his advisor Pongsakorn Kanjanaboos (right). Credit: Pongsakorn Kanjanaboos, Mahidol University.

Further, one of the advantages of perovskites is that they are solution-processable, meaning that a solar cell is made by drying liquid perovskite into a solid at a low temperature. This fabrication process is much easier and less expensive than making a traditional silicon solar cell, a process that requires very high temperatures and cutting a solid material into wafers.

However, the solution process typically used to make perovskites does not allow multilayer designs because the upper layer tends to dissolve the already-dried lower layer. To overcome this challenge, the researchers turned to a process known as sequential spray deposition in which tiny droplets of material are applied to a surface.

After trying different spray coating methods, they found one that worked at temperatures around 100 °C. They then optimised the spray parameters to ensure that the tiny droplets dried and crystallised into solid perovskite immediately upon contact with the already-dried lower layer.

“With our spray coating process, the solution of the upper layer doesn’t disturb the solid film making up the first layer,” said Pongsakorn. “Endless combinations of stacked perovskite architectures with any number of layers can be designed and created with precise control of thicknesses and rates of deposition for each layer.”

The team plans to use the new approach to make multilayer perovskite devices with new functions and combinations of performance and stability that were not possible before.

Source: saurenergy.com

(Visited 13 times, 1 visits today)

Leave a Reply

Your email address will not be published. Required fields are marked *

4 × 3 =